The Experts below are selected from a list of 309 Experts worldwide ranked by ideXlab platform
Panagiota Tsarouchi - One of the best experts on this subject based on the ideXlab platform.
-
Good practices in sensors' selection
internal, 2018Co-Authors: Panagiota TsarouchiAbstract:; if not, the razor is ejected at the exit from the machine. image2018-5-7_10-52-40.png H: Razor head locking (up/down move) Analog proximity sensors … and decides whether defective razor(s) head(s) should be ejected. A photocell sensor checks whether the defective head has been rejected. A solenoid valve
Elena Kokoliou - One of the best experts on this subject based on the ideXlab platform.
-
Deposition methods
internal, 2017Co-Authors: Elena KokoliouAbstract:of the target with more material atoms being ejected. Beyond this level, higher working pressure implies higher number of collisions and low mean free path denoting … bombarding of the target with more material atoms being ejected. Beyond this level, higher working pressure implies higher number of collisions and low mean free
-
Knowledge base
internal, 2017Co-Authors: Elena KokoliouAbstract:in a localised area. A co-axial gas jet is used to eject the molten material and create a kerf. A continuous cut is produced by moving the laser beam or workpiece
Athina Brintaki - One of the best experts on this subject based on the ideXlab platform.
-
Print&Decor_RF SoAR _v2.docx
internal, 2017Co-Authors: Athina BrintakiAbstract:CITATION Str14 \l 1033 (I.T. Strategies, 2014). As shown in Fig. 10 inkjet printing covers a wide range of technologies involving ejection of ink droplets from … \l 1033 (Castrejon-Pita, et al., 2013). In other words, inkjet printing is a mechanism for controlled ejection of discrete drops of fluid. The printed
Eleni Milioni - One of the best experts on this subject based on the ideXlab platform.
-
US4662837.pdf
internal, 2020Co-Authors: Eleni MilioniAbstract:is opened by moving platen 19 away from platen 20 by means not shown to permit article 23 to be ejected from die cavity 18. The valve pin is not essential
-
US6428305.pdf
internal, 2020Co-Authors: Eleni MilioniAbstract:one or more orifices for ejecting the molten material into the mold. A heating assembly in each nozzle assembly maintains the plastic material in a molten
Nikos Chatzigrigoriou - One of the best experts on this subject based on the ideXlab platform.
-
NP122 vs. C489_sigma_soft_calculation.pdf
internal, 2018Co-Authors: Nikos ChatzigrigoriouAbstract:. C489 / BIC o Mold temperature: 16°C o Ejection temperature: approx. 215°C o Injection time: C1: 1,65s, C2: 1,8s o After preassure: C1: 100% of max. Fülldrucks
-
BIC Shavers - Processing of Plastics
internal, 2017Co-Authors: Nikos ChatzigrigoriouAbstract:channels design) Type of plastic raw material (melt temperature, ejection temperature, thermal conductivity, heat capacity) b. Part design parameters
-
Thermoplastic Elastomers.pdf
internal, 2017Co-Authors: Nikos ChatzigrigoriouAbstract:and the mold is opened, the finished product is ejected and the process continues. The injection molding process is capable in producing a variety of parts … which is then transferred to the blow mold where it is blown and ejected from the machine. In the two- stage process, preform is injection-molded, stored
